时间因素对钻屑瓦斯解吸指标K1值测定的影响分析

针对时间因素对钻屑瓦斯解吸指标K1测定结果的影响，采用恒温瓦斯放散试验深入分析钻屑瓦斯解吸指标K1测定理论的准确性，总结因时间因素导致K1值测定误差所带来的现场问题。研究结果表明:K1值的测定误差与时间关系密切，测定启动时间越晚，误差越大；测定启动时间由第1 min延后至第2 min，绝对误差和相对误差最大值分别增加0.081 cm3/(g·min1/2)和2.20%；高瓦斯压力条件矿井或煤层的局部高瓦斯压力区域、构造煤发育区的钻屑瓦斯解吸指标K1值测定结果偏低，测定误差偏大。研究结果可为煤与瓦斯突出预测水平的提升提供技术支撑。     

近距煤层无煤柱协调开采布局研究与应用*

为了解决老母矿近距煤层的开采难题,通过理论分析并利用FLAC 3D数值模拟软件进行模拟,分析出煤层前后推进150 m是最合理的步距，侧向采动支撑压力在15~50 m内存在影响。基于这些理论数据，确定回采巷道的合理位置,进而确定以内错距离范围为30~60 m的内错式布置方式布置巷道和无煤柱协调开采布局，并进行井下工程应用。最后把无煤柱协调开采布局与双巷掘进开采布局对比，得出无煤柱协调开采布局的先进性和优势，研究结果可为同类条件下的工程应用提供借鉴。     

深部煤层钻屑粒度随钻进深度分布规律

为了研究煤层钻屑粒度随钻进深度分布规律，选取具有冲击危险性的平煤八矿己15煤作为研究对象，采取钻屑量测试和孔口瓦斯浓度监测，通过筛分实验煤样并应用Rosin Rammler分布模型，探究了钻屑粒度和钻屑量大小随孔深变化关系，分析不同点钻屑粒度分布特征。结果表明:小于0.075 mm钻屑粒度分布随孔深变化与钻屑量变化规律相吻合；不同钻孔随深度变化分别对应不同Rosin Rammler分布函数，随着应力过渡越平缓，粒径分布宽度系数n值越小，煤体应力越大粒径相关系数D越大；不同范围钻屑粒度占比大小也会影响钻屑量大小；在钻屑量较大时，孔口瓦斯体积分数会出现增高现象。通过对钻屑粒度分布规律分析，更好地了解深部煤体应力分布，有助于冲击危险的预警。     

Utilization of MSWI fly ash as partial cement or sand substitute with focus on cementing efficiency and health risk assessment

• Washed MSWI fly ash was used as partial cement or sand substitute. • Sand replacing is beneficial for strength, while cement replacement reduces strength. • Cementing efficiency factor and mortar pore structure explain the strength results. • Health risk assessment was conducted for MSWI fly ash blended cement mortar. • CR and HI contributed by different exposures and heavy metals were analyzed. The strength of cement substituted mortar decreases with the increase in fly ash amount, whereas the strength increases when the fly ash is blended as sand substitute. A mortar with highest strength (compressive strength= 30.2 Mpa; flexural strength= 7.0 Mpa) was obtained when the sand replacement ratio was 0.75%. The k value (cementing efficiency) of fly ash varied between 0.36 and 0.15 for the fly ash fraction in binder between 5% and 25%. The k values of fly ash used for sand replacement were all significantly above that used for cement substitution. The macropores assigned to the gaps between particles decreased when the fly ash was used as sand replacement, providing an explanation for the strength enhancement. The waste-extraction procedure (toxicity-sulphuric acid and nitric acid method (HJ/T 299-2007)) was used to evaluate metal leaching, indicating the reuse possibility of fly ash blended mortar. For the mortar with the mass ratio of fly ash to binder of 0.5%, the carcinogenic risks (CR) and non-carcinogenic hazard quotient (HQ) in sensitive scenario for blended mortar utilization were 9.66 × 10^-7 and 0.06, respectively; these results were both lower than the threshold values, showing an acceptable health risk. The CR (9.89 × 10^-5) and HQ (3.89) of the non-sensitive scenario for fly ash treatment exceeded the acceptable threshold values, indicating health risks to onsite workers. The main contributor to the carcinogenic and non-carcinogenic risk is Cr and Cd, respectively. The CR and HQ from inhalation was the main route of heavy metal exposure.     

走向工作面贯通上山与支架快速回撤技术

针对走向工作面停采线与上山之间的护巷煤柱造成煤炭损失，支架回撤工艺复杂、巷道掘进量大等问题，提出走向工作面贯通上山与支架快速回撤技术。工作面贯通采区上山，利用上山回撤支架。在贯通前，利用压力拱模型分析剩余煤柱应力变化规律，并结合极限平衡区公式，确定让压煤柱为8 m；对贯通前基本顶合理断裂位置、让压调节机制、末采阶段采高进行了分析确定，并采取上山巷内补强支护及挂绳铺网措施。贯通上山后，首先利用支架对上山留巷，完成留巷后，利用上山回撤支架，先将上部端头3架逆时针旋转90°作为掩护架，在对剩余支架逐架回撤时，3个掩护架呈现台阶型。提出的技术取消了护巷煤柱及回撤通道，提高了煤炭采出率，减少了巷道掘进量，简化了回撤工艺。     

Evaluation of the spontaneous combustion characteristics of coal of different metamorphic degrees based on a temperature-programmed oil bath experimental system

Research on the micro- and macrocharacteristics of different metamorphic degrees of coal helps improve the control and protection techniques used during spontaneous combustion. Nine coals with different properties were thoroughly investigated in this study. Fourier transform infrared spectroscopy and a self-designed temperature-programmed oil bath experimental system were adopted to analyze the molecular structure and macrocharacteristic parameters of the spontaneous combustion of coal. Additionally, the influence of particle size on spontaneous combustion was considered. Various functional groups were employed as microcharacteristic parameters to capture the principal active groups in oxidation. The gas production rate, oxygen consumption rate, gas concentration, heat energy release rate, and characteristic temperatures were evaluated as macrocharacteristic parameters to investigate the changes in coal during oxidation. The results establish that the microcharacteristics of coal molecules determine the degree of spontaneous combustion based on intrinsic properties and that changes in the macrocharacteristics of the spontaneous combustion of coal reflect the microstructural changes. The contents of the hydroxyl groups, carbonyl groups, alkyl ether and aryl ether in the coal molecules gradually decrease with the metamorphic increase. Oxygen-containing functional groups have higher reactivities and easily react with oxygen, causing the macroparameters, such as the oxygen consumption rate, the gas generation rate and the heat energy release rate, to consistently decrease with the increase of the metamorphic degree. Small-particle-size coal molecules have more active aliphatic hydrocarbons, oxygen-containing functional groups and a larger specific surface area, increasing the chances of adsorbing the oxygen of active groups and promoting the reaction between coal and oxygen. The experimental results indicate that coal samples with higher metamorphic degrees or larger sizes exhibit lower tendencies toward spontaneous combustion. Evaluation of the spontaneous combustion of coal based on a temperature-programmed oil bath experimental system is of great practical importance for preventing the spontaneous combustion of coal during storage, processing and utilization and can serve as a convenient reference for production safety in mining applications.     

基于模糊聚类关联分析法的煤与瓦斯突出程度分析

运用模糊聚类分析方法对煤与瓦斯突出的样本集合进行分类,建立了不同突出程度的模糊模式.用关联分析确定待分析样本与模式的关联程度,以此预测预报样本的煤与瓦斯突出危险程度.实例分析表明,与模糊聚类分类后、将模式与待预报样本组成新样本集合进行聚类分析并以此分类结果进行预报的方法相比,这种预报方法不仅可靠程度高,而且能定量描述待报样本与模式的亲和程度.     

民用燃煤源中多环芳烃排放因子实测及其影响因素研究

民用燃煤是我国目前关注较多的多环芳烃(polycyclic aromatic hydrocarbons,PAHs)排放源.根据我国民用燃煤所涉及的煤种、燃烧方式和炉灶类型,利用全流稀释采样系统对5种不同成熟度的煤种,分别以散块煤和蜂窝煤形式在3种炉灶类型中燃烧产生的烟气进行了采样和分析,初步获取了我国民用燃煤烟气中PAHs排放因子(EFPAHs)的实测数据.结果表明,烟煤的EFPAHs在块煤燃烧方式下的变化范围为1.1～3.9 mg.kg-1,在蜂窝煤燃烧方式下的变化范围为2.5～21.1 mg.kg-1,无烟煤的EFPAHs在块煤与蜂窝煤燃烧方式下分别为0.2 mg.kg-1与0.6 mg.kg-1.在民用燃煤的EFPAHs的各种影响因素中,煤的地质成熟度起主导作用,不同成熟度煤种的EFPAHs差异幅度高达1～2个数量级.其次是燃烧形态(块煤/蜂窝煤),主要表现为同一种地质成熟度的煤在蜂窝煤燃烧方式下排放的PAHs比块煤高2～6倍.炉灶类型的影响最小.     

Structural equation model of the influence of noise annoyance on miners’ unsafe behavior in coal mines

Miners' unsafe behavior (UB) is the main cause of coal mine accidents. Previous research has suggested that excessive noise in tunnels impacts miners' temperaments and safe production behavior. To explore the influence of noise on UB, four different dimensions of noise annoyance were identified: cognitive, emotional, communication, and physical mechanism annoyance. The coal mine noise annoyance scale, miners' unsafe behavior intention (UBI) scale, and miners’ UB scale were developed according to different dimensions. In the first survey, a total of 200 questionnaires were distributed in the two coal mines, and 193 valid questionnaires were recovered. Exploratory factor analysis was conducted, and invalid items were removed according to the analysis results to form the final scale. Then, 500 final scales were distributed in two Chinese coal mines, and 482 valid questionnaires were collected. Confirmatory factor analysis was conducted by collating the data of the second questionnaire. Based upon the structural equation model (SEM), the SEM of the influence of noise annoyance degree on UB and the path analysis with latent variable path analysis with the latent variables (PA-LVs) mediating model of the effect of UBI on UB were established, and the path coefficients with fitting data of the model were analyzed. The results indicated that the four dimensions of coal mine noise annoyance had a strong positive impact on UB, which was reduced by less noise annoyance. In addition, the Bootstrap method was used to verify the mediating method among the four dimensions of noise annoyance, cognitive annoyance, emotional annoyance, with communication annoyance indirectly affecting UB through UBI. The research results provide theoretical support for reducing the UB of miners and improving coal mine safety levels.     

小煤柱巷道围岩变形的力学机理及演化过程研究

为研究小煤柱巷道围岩变形力学机理与演化过程,以石槽村矿某回风巷为研究对象,采用理论分析、FLAC3D数值模拟以及现场实测等方法,分析小煤柱条件下巷道围岩变形的主要影响因素以及表征特点。研究结果表明:侧压系数为巷道围岩变形的主控因素;侧压系数与巷道顶底板位移量呈正比关系,与两帮位移量呈反比关系;回风巷每次受采动影响时,变形可分为巷道稳定阶段、位移分化阶段以及位移加速变化阶段;围岩变形主要发生在一次采动影响时,此时巷道变形呈现明显的不对称,左右两帮的位移量差异明显,巷道的中心位置明显偏移。研究结果可为小煤柱巷道围岩支护提供技术参考。